![]() This allows you to see the pulls from multiple angles before making your final decision location. This unique putty can be applied to the back of your new pulls and will hold those pulls in place on the cabinet. Tip: If your cabinet door does not have a stile or you are unsure of where you want your knob or handle to be located on a drawer or cabinet face, buy museum putty. We strongly recommend using jigs to install cabinet pulls and will only cover this method due to its precision and reproducible results. On the off chance that you are working with unfinished cabinets, make sure to paint the cabinets with a sprayer first before adding the pulls. You could also work with a stainable wood filler instead of a putty. You are now read to drill your new holes for cabinet pulls.Gently scrape a smooth surface with the putty knife on the inside and outside of the cabinet.Continue working putty into the screw holes with a putty knife until putty extrudes through the opposite side of the screw hole.Use a putty knife to apply small amounts of wood putty directly to the hole.To apply your wood putty to fill pre-existing holes for cabinet pulls: Woody putty is preferable in this situation because it will not crack or shrink. Wood putty cannot be stained, so choose carefully. If your cabinets are stained wood, I recommend detaching a cabinet door and taking it to your local home improvement store. Go to the wood putty selection and carefully select the wood putty that most closely matches your cabinet’s finish. Preparing for New Pulls on Wood Stained Cabinets Even if the holes seemingly match up, it is often a good idea to fill the holes and start with fresh cabinet faces to ensure your desired results. Old cabinet pull screw holes are often oversized due to their use over time. Tip: This method also works well for new cabinet pulls that match up with existing holes. After the wood filler has dried per manufacturer’s instructions, paint over the screw holes with a matching paint.When hole is completely filled, use a putty knife to smooth the interior and exterior surfaces.Repeat steps 2 & 3 until wood filler is pushed entirely through the existing screw holes into the interior of the cabinet.Use a putty knife to work wood filler into the hole.Apply small dabs of wood filler to existing holes.If your cabinets are painted, you will need to fill the holes from the old cabinet using paintable wood filler. Preparing for New Pulls on Painted Cabinets If you are drilling holes in wood for new cabinet pulls in existing cabinets, your first step is to prepare the surface. ![]() Sometimes screws included with drawer pull packages are not long enough. Screws need to be long enough to pass through both of these and into your cabinet pulls. Many drawers have a drawer box and an additional drawer face. Tip: When purchasing new hardware, be sure to consider the screw length. Two-screw handles often stay secured longer, while single-screw knobs need to be attended to more often. Knobs normally require a single screw while handles usually require two. It is worth considering the amount of holes you will be putting into your cabinet. If you have high-end burlwood upper cabinets, an inconspicuous knob may be a better option to keep the limelight on your cabinets. ![]() For many large lower drawers that can be filled with heavier kitchen equipment, handles make opening drawers easier. Consider Knobs or HandlesĬabinets with knob pulls or handle pulls offer different advantages. Backplates often have predrilled holes for your new cabinet pulls.įor some, squaring a backplate on the drawer surface is easier than correctly locating screw holes for new pulls. These plates hide existing holes and can speed up the installation process.īackplates do not require filling old screw holes or sanding prior to installation. Backplates are flat pieces which will rest between your cabinet pull and the cabinet itself. You may look for cabinet pulls that include backplates. If you are looking to replace existing cabinet pulls, you have a few options. You will need to be able to measure the drawer pulls before drilling any holes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |